PicoSSR 3 is one of the most compact MOSFET for AEG. It’s small dimensions (4x6x21 mm) give the user the option to use it even in most confined spaces – it’s size do not prevent it from being very powerful. It can work with the strongest AEG replicas - 12.8V maximum battery voltage. It is also fully resistant to water immersion (after heatshrink tube fitting). MOSFET transmits the energy from the battery directly to the motor, bypassing the traditional mechanical trigger contacts. As a result, the replica gains a higher rate of fire, faster trigger response, and the contacts are protected against burn out. Included in the kit: PicoSSR 3 2 x single signal wire for trigger contacts, each 60cm long 3 x heat shrink tube
Warning: PicoSSR 3 is not compatible with micro-switches!
NanoHARD is a multifunctional programmable AEG Controller. It has 8 functions. Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C). Battery protection supports: Li-Po 7.4V / 11.1V / 14.8V.
You can also disable the protection and use other batteries.
PicoAAB is the smallest, 3rd generation mosfet with Active Brake. It can work with 14.8V Li-Poly batteries. The mosfet can be installed in every AEG. It can work with the strongest AEG replicas.
The installation is very easy and the interference in the replica is limited only to running one or two additional wires from the contacts.
This website uses cookies to ensure you get the best experience on our website